Progress on my O9 (On18) tool van has been a little slower than I had planned.
I sprayed the tool van with primer, but the finish wasn’t smooth enough. The only solution was to sand the van until the surface was even.
Sometimes my modelling feels like two steps forward and one step back. This was one of those times 🙂
Fortunately the second coat looked better. I like the grey of Humbrol primer, so the van will be ‘primer grey’. The inside was painted cream and the outside brushed with brown weathering powder.
I detailed the interior with four spades hanging on hooks and a shelf with a paint pot and a cardboard box. On the floor are some fence posts and a sledge hammer.
On the other side of the door I placed a rucksack made from some DAS clay and strips of card.
The figure hasn’t been glued in place yet. You can see the hole where I’ll attach him.
I think the interior is complete. Now I’ll switch my attention to the top and the bottom of the van.
It’s time to fit the bogies and the roof.